How to Repair and Replace Pachislo Stop Reel Buttons
Two types of main buttons
1. Assembly of the stop button
2. Individual stop buttons
Stop Button Assembly
All the buttons are combined in a single set. The entire assembly is easily removed from the machine by removing two screws.
Each button has a connector that connects to a main board in the set, that board has a connector that connects to the Pachislo machine.
Disconnect the assembly connector, remove the two screws and remove the assembly from the machine.
In most cases, you can remove the board from the assembly by removing a screw, a few clips, or both. Once the back of the buttons is exposed, you can remove each one by unscrewing a plastic nut that holds them in place, or by pressing in two clips that hold them in place.
If your buttons have clips, just use a small flathead screwdriver. Lightly depress a clip while gently pushing it through the front of the assembly. DO NOT FORCE IT. Just loosen the first side by pressing the clip.
Now do the same for the other clip and it should come out the front of the assembly.
Individual stop buttons
The second type is the single stop button. In this case, they are not part of a set. Each one is individually connected to the machine. Disconnect them individually from the dash and follow the same instructions to loosen the clips and remove them from the front of the machine.
repair buttons
The most common problem with buttons is that they get sticky and don’t push or stick. To solve this problem, you may not need to replace them or even remove them.
Use a silicone spray. Press the button if possible. Spray a SMALL AMOUNT of silicone spray into corners of button and wipe off excess quickly. Move the button in and out for a few seconds to allow the silicone to work on the areas around the button.
button replacement
This can be difficult. You won’t be able to find new buttons, but some buttons from discarded machines can be found online. Not only will you need to match the button style and size, but you’ll also need to match the button’s connector.
There are many different types of connectors and you will need to match the style and number of pins.
